Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - paulm

Pages: [1]
1
General Discussion / Re: UltraGauge cannot be set to metric
« on: August 18, 2010, 07:17:57 PM »
Any plans on updating the UltraGauge to support metric units? Should be a minor programming update.

2
General Discussion / UltraGauge cannot be set to metric
« on: August 16, 2010, 07:44:09 PM »
I took a look at the manual and correct me if I'm wrong but the UltraGauge cannot be set to metric units.  :-[
Too bad, I guess my only alternative is the ScanGauge.

Pages: [1]