Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - 98whitelightnin

Pages: [1]
1
General Discussion / Re: digital readout quit
« on: April 30, 2011, 05:13:02 PM »
It hasnt been overheated as its been out of the sun most of its life and just recently put it on one of those a/c vent mounts. It looks brand new and am ocd about fingerprints on the screen so I dont touch the screen either. I just noticed one day that the bottom line was missing. :(

2
General Discussion / digital readout quit
« on: April 23, 2011, 04:23:20 PM »
The bottom line on all the pages has quit lighting up the numbers and letters. I have DTE and DST TRP and the DTE looks like DTF. Anyone else have this hapenning?

3
General Discussion / Re: Calibration
« on: October 27, 2010, 08:11:23 PM »
I dont really understand this either. I have larger tires so I expect the trip in my dash to not be correct. I stop at a mile marker on the interstate and travel 10 miles. Stop at the tenth mile marker and do the celibration and it says to change the numbers it shows to 1.000 but when I do that it sets it exactly to the trip in my dash which is wrong because of the larger tires. Am I doing this right or do I need to enter the actual miles I have traveled and not make it go to 1.000?

4
General Discussion / Re: error codes
« on: October 22, 2010, 04:00:43 PM »
Mine doesnt have "clear trouble codes" but it does have clear check engine light so I used that and it cleared the codes.

5
General Discussion / Re: error codes
« on: October 20, 2010, 01:43:49 PM »
How do I do this?

6
General Discussion / error codes
« on: October 19, 2010, 08:58:19 PM »
Does the ultra-gauge erase error codes automatically or can I manually erase them with the ultra-gauge?

Pages: [1]