Author Topic: UltraGauge and SYNC Equiped Fords  (Read 4296 times)

Offline rkildu

  • Newbie Gearhead
  • *
  • Posts: 6
    • View Profile
UltraGauge and SYNC Equiped Fords
« on: March 07, 2011, 06:06:34 PM »
I don't know if this has been covered elsewhere.  I tried to run a "Vehicle Health Report" on my 2010 F150 today for the first time since installing UltraGauge.  I kept getting a response that the "report could not run" or something similar.  I tried three or four times with no success. 

Then I got to thinking about the UltraGauge plugged into the ODBC data port might be a problem.  So I turned off the ignition,  unplugged the device and restarted.  After letting the engine run the required one minute, I executed the Vehicle Health Report one more time.

SUCCESS!

I then shut down,  replugged the gauge into the port and restarted.  It went through rediscovery again but seemed to have all current correct data.  This included a redefined gauge.

I have one question:  Did the unit save my calibration settings?

Thanks
Rod

Offline UltraGauge Admin

  • Administrator
  • Sr. Member Gearhead
  • *****
  • Posts: 364
    • View Profile
Re: UltraGauge and SYNC Equiped Fords
« Reply #1 on: March 08, 2011, 10:19:50 AM »

Rod,

UG remembers all settings, accumulated data, and calibration, even when unplugged.